Setting Up and Connecting
Assemble the QuickQ Console
-
Connect the Tablet Holder to the back of the console using the two captive screws.
-
Install the aerial on to the connector labelled antenna and extend it vertically.
-
Connect the Desk Lamp to the lower USB on the rear of the console.
-
Connect the DMX outputs to the fixtures that are to be controlled.
-
Connect a Network Cable to the Network port if using.
-
Connect an HDMI Monitor if you decide to use one.
-
Connect the power supply into the 12V DC input on the back, then connect it into a mains AC power.
Connecting the Remote App to a QuickQ Console
| QuickQ Consoles are shipped with the WiFi interface disabled. You must enable the interface the first time before attempting to connect. |
-
Turn on WiFi: Press the icon on the top bar and turn the Status switch on.
-
Download the App: The QuickQ Remote App is available for free download from the Google Play and Apple App Stores.
-
Scan the QR Code: Use the Remote App to scan the QR Code displayed on the Console touchscreen.
Assemble the QuickQ Rack
-
Connect the Rack Ears to the front of the unit with the small screws supplied.
-
Install the aerial on to the connector labelled antenna and extend it vertically.
-
Connect the DMX outputs to the fixtures.
-
Connect a Network Cable to the Network port, if using.
-
If not using QuickQ App for programming, connect an HDMI Monitor and USB Mouse.
-
Connect the PowerCON TRUE1 connector on the rear of the QuickQ Rack, then connect it into a mains AC power
Connecting the Remote App to a QuickQ Rack
| QuickQ racks are shipped with the WiFi interface disabled. You must enable the interface the first time before attempting to connect. |
-
Enable the WiFi Press and hold the WiFi button on the rear of the unit for 2 seconds. The LEDs on the front of the Rack will flash blue to indicate that it has been turned on or red to show it has been turned off.
-
Scan the QR Code Use the Remote App to scan the QR Code supplied on a printed sheet with the Rack.